Default Gateway Cisco. How to Configure IPv6 on CISCO Router? Here is what Cisco says: ip default-gateway 171.55.31.1 !--- This is the default gateway when routing is disabled The default gateway is the first Layer 3 device (such as a router) on the same management VLAN network to which the switch connects
SG25050 default gateway Cisco Community from community.cisco.com
Use the ip default-gateway command when ip routing is disabled on a Cisco router The way in which routing protocols propagate the default route information varies for each protocol.
SG25050 default gateway Cisco Community
You provide the default gateway as the management interface SVI on SW1 or SW4 based on where in the network you are located The default gateway is the first Layer 3 device (such as a router) on the same management VLAN network to which the switch connects On SW2 and SW3 you will put ip default-gateway 192.168.100.1
SG25050 default gateway Cisco Community. Once the default gateway is configured, the switch has connectivity to the remote networks with which a host needs to communicate If the actual default gateway is enabled for proxy arp/auto arp response, then automatically the reachability to the switch from another subnet will indeed work - perhaps.
How to set default gateway on cisco switch poollasopa. On SW2 and SW3 you will put ip default-gateway 192.168.100.1 Use the ip default-gateway command when ip routing is disabled on a Cisco router